Notices
 

Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles
Filter by: Last 7 Days Clear All
  • FarmallMan's Avatar
    05-23-2017, 09:56 PM
    In theory, you could buy just the thermal breaker and epoxy it to the outside of the motor with a metal filled epoxy like JB Weld (helps with thermal...
    16 replies | 765 view(s)
  • aggie20's Avatar
    05-23-2017, 05:48 PM
    I had the same issue on a New Idea EGT100 I worked on over the winter. I purchased a new circuit breaker assembly from Harold at Clean Power Supply,...
    16 replies | 765 view(s)
  • ahirbe's Avatar
    05-23-2017, 08:30 AM
    How about a thermal circuit inline with wires 3 and 12? something that would be close to the thermal capacity as what is in the motor?
    16 replies | 765 view(s)
  • FarmallMan's Avatar
    05-22-2017, 09:56 PM
    The two spade terminals on the motor are connected to a thermal circuit breaker. It's purpose is to shut the motor down in the event that it...
    16 replies | 765 view(s)
  • ahirbe's Avatar
    05-22-2017, 07:54 AM
    I have tried those terminals both ways and get no results. I will check it later for continuity, but is there a bypass or a switch I could add to...
    16 replies | 765 view(s)
  • FarmallMan's Avatar
    05-21-2017, 10:16 AM
    Is the connector with the two wire 12s attached to the other spade on the motor? If not, connect them to it and reconnect wire 3 to the other...
    16 replies | 765 view(s)
  • ahirbe's Avatar
    05-19-2017, 08:42 AM
    OK I switched wire 5 & 11, that seems to work. Now when I sit on the seat and flip the switch the blade motors will turn on and vice versa. However...
    16 replies | 765 view(s)
  • FarmallMan's Avatar
    05-17-2017, 03:54 PM
    Sure, happy to help. If you're connecting wire 3 to the negative side of the drive motor, you are bypassing the seat switch. The motor will always...
    16 replies | 765 view(s)
  • ahirbe's Avatar
    05-17-2017, 03:09 PM
    I am touching it to the Negative on the Drive motor, but I found out today that if I touch wire 3 to any bare metal it will engage the drive motor. I...
    16 replies | 765 view(s)
  • FarmallMan's Avatar
    05-17-2017, 02:53 PM
    I'm taking a look at things and thinking that deck motors running without any input from the switch is due to wires being placed in the wrong spot on...
    16 replies | 765 view(s)
No More Results