Notices
 
Results 1 to 2 of 2
  1. E15 brake pad replacement- How do I change the discs? 
    #1
    Junior Member
    Join Date
    Oct 2005
    Location
    Rhinelander, WI
    Posts
    29
    Mine has the round style disc pads.

    How do I change them?

    Thanks!
     
     

  2. Re: E15 brake pad replacement- How do I change the discs? 
    #2
    Basically need to jack up the rear end, remove the left rear wheel. Support the rear axle with jack stands, loosen the two bolts that hold the transaxle to the frame of the left side, and jack up the frame another ~1/2". The tractor body should raise while the transaxle sits on the jack stand, giving just a little extra working room around the brakes.

    Remove the caliper assembly. It comes apart into two halves. The pad on the stationary side gets glued into place (be sure to scrape off all old glue first). The pad on the active side with the lever and pins is free to move. Should be a thin metal disk behind the pad to protect the pad from direct contact with the two push pins.

    Clean any surface rust off of the brake disk. Re-install the caliper assembly. Lower the jack, tighten the bolts holding the transaxle to the body.

    See pages 1-23 through 1-26 of the Homeowners Service manual for adjusting the brakes and then adjusting the brake switch.

    Replace wheel, remove jack stands when done.

    (by memory - others may notice missing steps :-)
    Jim Coate, 540-941-1005
    Order Elec-Trak parts on-line:
    www.ElectricTractorStore.com
     
     

Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •